[FourWerx]

I had a few guys mention that one of these would be nice so we your leaning back you don't burn your boot/leg/pants on the exhaust that comes out by the rear fender.

I made something up. What do you think?

100% carbon fiber
Heat taped on rear
Hardware included

$68.00 shipped w/ stainless hardware in the US

( wait time may be present on CF part since they are hand made )

 

[Lost Down Under]

Cost shipped to Australia?
What's your pay pal addy?

 

[FourWerx]

I will have to check on shipping for you. Pm me your address please.

Thanks, Jay

 

[Lost Down Under]

Done.

 

[the devil wears FSAS]

what does it screw into? right into the pipe??

 

[FourWerx]

Basically you get hose clamps with the kit, and also some threaded brackets that the boles screw into.

I had alot of trouble finding something to secure them, and finally came up with this. Its a simple yet good system.

Thanks, Jay

 

[CodeRed30]

That looks sick! Will it fade after alot of sunlight and dirt? And will it fit on the Outlaw 450?

 

[FourWerx]

I'm not sure that it will fade, it shouldn't. It should fit an outlaw, but I do not have one here to check into ....

Thanks, Jay

 

[FourWerx]

Just wanted to let you guys know that I'll have 5 in stock by the end of the week.

I am looking to get these boxed and ready to go, so if you need one, let me know and I'll get a box ready for you so once they are done, we can get it in the mail for ya.

Thanks, Jay

 

[the devil wears FSAS]

can u ship to canada?? and if so how much to ship to grande prairie,alberta?

 

[NCXCRACER]

how much for product plus ship to NC 27591

 

[FourWerx]

I will check on shipping to Canada, but can you pm me your actual addy?

NCXCRACER: $68.00 shipped to North Carolina....


Out of stock for now til I get the 4 done.

thanks, Jay

 

[FourWerx]

4 more in stock guys! Let me know if you want one. I'll get it out to ya.

Thanks, Jay

 

[tapped out]

Workout a price shipped to Australia, and email me your paypal address. Cheers Ben

 

[FourWerx]

Pm'd you.

Thanks, Jay

 

[Lost Down Under]

Arrived this morning.
Top job on the carbon.
Want to put a pic up of how you mounted the brackets & washers.

 

[FourWerx]

I will post some pics of the setups. I'm not the most organized since these were so quick to be a hot item.

I'll post some install pics though.

Thanks, Jay

 

[FourWerx]

Directions for Install:

Install hose clamp around exhaust and make sure the black hardware peice is installed with hose clamp running thru it. Make sure the threaded side is sticking out towards the heatshield. Adjust to your liking and mock up fitment. Do this with both of the clamps and you can use the nylon washers if wanted. Good luck. This is what the clamp/hardware should look like installed.

 

[FourWerx]

Got 3 more in stock as of NOW.

 

[FourWerx]

5 IN STOCK! Get yours today!