[Bronson90]

Just got one, thought I read it was plug n play. Does it matter which wire goes where? I think I can take these wires out of the of the Honda plug and put them in the ktm plug.

Any info is greatly appreciated, thanks in advance!

 

[Lost Down Under]

I cut the wires off the KTM plug about 2" up the wire from the throttle & soldered the wires from the Honda throttle staright on. That way I still have the origional plug.
I did twist them together first to make sure it started & reved properly before soldering.
There is only 2 wires & it didn't seem to matter which way they went.
I found the bike started without the wires plugged in, but would not rev past about 1/3 throttle.

Clear as mud?